Tension Transducer Strain Gauge Amplifier Small Size For Tension
Load cell Tension Control
Tension Transducer Tension Amplifier Work With Tension LoadCell for
Flim Winding Machine
Tension transducer STA - 05 is the tension of Intelli gent tension
transducer instrument . By using of key operation will complete
zero alignment,calibration,convert the left or right tension sensor
signal into astan dard industrial control signals, 0 ~ 10V / 0 ~ 5V
and 0 ~ 20 mA output signal can be provided to PLC for automatic
1. Key intelligent operation,outside without adjust potentiometer.
2. Hardware and software to restrain power frequency interference,
output steady and reliable.
3. Adapt DIN-rail mounting,easy and convenient.
4. Adapt SMT ,small size,light weight.
5. Tension controller with STS ans STSA for option.
|Power Supply||DC 24V|
|Input Analog singal||L+~L-;R+~R-;Left,right STS tension loadcell signal (0~200mv,power
supply DC5V)||L+~L-;R+~R-;Left,right STSA tension loadcell signal (0~15mv;power
|Fixed output||5V+-GND:DC5V tension loadcell power supply|
3. Operation and using
1)The signal is too big, reason as follows:
a. The mass of weight is more than the range of tension
sensor,please confirm the weights and the rated value of tension
b. STA-05B can only use the Strain- gauge sensor
2)The signal is too small,reason as follows:
a. Wrap angle is too large,please wrap again and reduce the wrap
b. The force caused by film tension point to the screw ends of
tension detector,please change the directi-
on of then sensor.
c. STA-05C can only use the Differential sensor.
d. Tension detector malfunctions, please replace it;
The wrong wiring ,please re- wiring;The cable is damaged,please
STA-05 Tension signal amplifier.pdf